![current weather wall sd current weather wall sd](https://media.cbs19.tv/assets/KYTX/images/55f90f0e-9b63-4c0c-bd72-c0aef1e79318/55f90f0e-9b63-4c0c-bd72-c0aef1e79318_1140x641.jpg)
The axle will be on the tailgate side of the system. You should have the correct tailgate ammo can for this step.The C-channel endplate must rest on the cab side ammo can.Place C-channel on the inside ledges of a cabside ammo can and tailgate ammo can.Using the assembly just built as support, assemble the passenger side.If you must use power tools, use them with caution! Bolt the deck to the center vert BAG B1 (no washers).Now tighten the loose bolts connecting the ammo cans to the C-channel.Use the above bolts to bolt the deck to the ammo cans BAG B1 for the tailgate ammo can, BAG CS AMMO CAN for the cab side ammo can.
![current weather wall sd current weather wall sd](https://www.gannett-cdn.com/presto/2019/10/10/PSIF/ea81add1-c0d7-47cc-ac94-569db775051d-EGhwYJuU8AonZT9.jpg)
Current weather wall sd install#
Use WASHERS bag to install nylon & rubber washers on all CS AMMO CAN bolts.Hey Sparky: Tailgate end of the center vert has an axle installed the center vert axle and ammo can axles must be on the tailgate end (not the cab side end) of the assembly. Line up the driver’s side deck (sticker or mark on the end of deck panel indicates LEFT/DRIVER) on top of the C-channel/ammo can assembly and the center vert bosses.Houston, come in Houston, do you copy? Don’t tighten yet.
![current weather wall sd current weather wall sd](https://res.cloudinary.com/lakelink/image/fetch/c_fill,w_800,h_400,g_north/http://www.lake-link.com/images/memberLakeMaps/SD_Minnehaha_WallLake_20281.png)
Make sure the bolt head is in the C-channel, not inside the ammo can BAG C-CHANNEL.
Current weather wall sd driver#
Remove all factory tie-downs on both sides of the truck bed (T40 Torx driver required).NOTE: You will need a buddy to help with exactly two steps. TAILGATE ammo cans have wide bottoms CAB SIDE ammo cans have narrow bottoms. There is a straight screwdriver slot on the underside of the threaded insert. The inserts will replace any stripped inserts in the tailgate ammo cans or front face of the center vert at the bottle opener, but NOT THE TOP OF THE CENTER VERT, so hand tightens until snug only! You can also screw the inserts back in if dislocated. That’s all you get unless you call us and ask for more. NOTE* Two extra threaded inserts are included in BAG PREP-EXTRA. Just get ’em good and snug enough to keep the system from moving in the bed. Don’t over-tighten J-hooks during installation.Start all bolts with fingers to avoid cross-threading.If you don’t follow directions and do use power tools:ġ).Don’t over-tighten bolts, get ’em’ hand-tight.Don’t go rogue on us, please read the instructions.HEY! TORQUE BOY: READ BEFORE YOU INSTALL DECKED DECKED carton HARDWARE box – bagged components LEFT/DRIVER DECK HALF – 1